Sparsh Bath Fittings
  • Your Language
Category
About Sparsh

Useful Guidelines

  • Keep the number of bends in the pipeline to a minimum and make it travel reduce the throttle pressure of water.
  • All the supply lines must have vent pipes to remove air lock and for smooth water flow.
  • Use 25mm pipelines rather than 20mm to ensure better water flow and to overcome reductions India of pipeline due to scaling inside the pipeline.
  • Test the working of all the concealed fitting/flush cock installed on a high pressure for leakage before plastering or fixing the tiles. Faulty product or faulty fitting will result waste of time and money.
  • Clean aerators at regular intervals.
  • Place the outlet pointing the overhead tank at least 25cm above the ground level of the tank. This prevents the flow of foreign particles and sand etc.
  • Clean the tank thoroughly before the supply stars.
  • Clean the fitting regularly with normal soap or chalk powder to remove scaling/stains.
  • Don't use harsh cleaning agents containing abrasives and acids instead use soft sponge of wet cloth soapy water/diluted vinegar to protect the colour coated finish.
  • Protect the product from dirt stains and other damages, cover them with cloth/polypack after their installation till they come into actual use.
  • Centre to centre distance for hot and cold inlet for all types of wall mounted mixture should be maintained at 165mm in which case any of our wall mixer from different ranges can be easily installed without any problem.
  • Look for SPARSH hologram on the product.
  • Flush valve and flush cock must be directly connected to overhead tank through 1.5''and 1'' water supply lines.
  • Concealed or flush cock must be installed with arrow mark in line with the direction of flow of water.
  • Geysers should be installed close to the point usage to reduce heat loss.
  • For hot and cold water mixers its is advisable to supply the cold water from the over head tank for proper mixing and to prevents scalding.
  • Don't use any sharp object to clean the product.
  • Strains or black/brown soap on the product this is result of salt deposit. Clean the product with mild detergent and wipe it with wet cloth regularly to avoid salt deposit. SPARSH bath fitting and shower are made o up of brass and these material will never get rusted.if not cleaned and maintained properly the salt and other minerals in the water will deposit on the product and it will me difficult to remove in course of time.
  • Always check the product thoroughly before installing the product. Never use wrench to fit any SPARSH product. If the product is damaged at the time of installation due to mishandling the product can not replaced.
  • SPARSH products are sophisticated and luxurious product. Hence proper care must be taken at the time of handling.
  • Never hold knob or use pressure on the knob while fitting. the taps. This may result in damaging the delicate spindle.
  • Water pressure depends on the storage capacity of the tank and height of the tank. The tank must be at least minimum 15feet high above the tap.
  • Apartments above four floors, pressure reducer is recommended.
  • Always block the water outflow pipeline before cleaning the over head tank.
  • Do not use too much of thread or cellar on the thread for fixing the tap. Use Teflon tape only.